Prep before you buff: wash, clay, tape
Most buffing problems start before the polisher comes out. Prep takes a small share of the day, and it decides whether the rest of the day goes well.
1. Wash properly
You want every bit of loose dirt off the paint, without adding new swirls while you do it.
- Rinse first to knock off loose grit.
- Use two buckets: one with car wash soap, one with plain water to rinse your mitt between panels.
- Wash top down, so the dirtiest lower panels are last.
- Dry with a clean, soft microfiber drying towel by blotting or gently dragging, not scrubbing.
Washing gear and pressure washers are covered on our sister site HydroWashers.com.
2. Clay the paint
Even clean paint carries bonded contamination: industrial fallout, tree sap, overspray and road tar. You can feel it as roughness. If you polish over it, the pad can drag those particles across the paint.
- Do the bag test. Put your hand inside a thin plastic sandwich bag and glide it over the clean paint. Rough or gritty means clay is worth doing.
- Use plenty of lubricant. Clay must glide on a wet film; never use clay on dry paint.
- Work small areas with light, straight back-and-forth passes until the clay glides smoothly.
- Fold the clay to a clean side often. If you drop it on the ground, throw that piece away.
- Wipe the area dry and re-check with the bag.
Clay can leave very light marring on soft paint. That is fine before buffing, because polishing removes it.
3. Tape trim, badges and edges
Automotive masking tape protects what you do not want to polish:
- Rubber seals and textured black plastic trim, which stain white with polish residue.
- Badges and emblems, where pads catch and product builds up.
- Sharp body lines and panel edges, where paint is thinnest.
Use tape made for automotive paint, not household tape, and remove it the same day.
4. Inspect and plan
With the car clean and taped, inspect every panel under strong light and note the worst areas. That tells you where to put your test spot and whether you need a compound step at all. Then follow How to buff a car, step by step.
Pick a kit
Budget beginner kit
Entry dual-action polisher sold with pads, plus a beginner-friendly compound and polish, clay, towels and spray wax. Built to a first-timer's budget.
See the kit →Complete correction kit
A mid-range dual-action polisher, dedicated cutting and polishing pads, a pro compound and finishing polish, plus prep, light, towels and protection.
See the kit →Black and dark paint kit
Built around the finishing step: soft pads, a fine finishing polish, extra towels and an inspection light, for paint that shows every mark.
See the kit →Questions
Do I really need to clay before buffing?
If the clean paint feels rough through a thin plastic bag, yes. Clay lifts bonded grit that the pad would otherwise drag across the paint.
Can clay mark the paint?
It can leave very light marring on soft paint. That is fine before buffing, because polishing removes it.
Why tape the car before polishing?
Tape protects rubber and textured trim from staining, keeps pads off badges, and protects sharp edges where paint is thinnest.